The equipment of our physical /electronical laboratory

In addition to common laboratory facilities following equipment is available.

Measuring equipment:

• EMV - Cabine, Fa. Frankonia Maße 

• Processor / processcontrol  HYDRA  from Co. Kinzinger. Installation in 19 inch – casing with
    12V voltage source for mobile operation. Real-time output, with approx 300 MS scan rate.

• 8 Channel ICP Sensor Unit, Vendor Synotech

• Measuringcards, National Instruments

• Spektrum - Analyser HP 8594 EMC

• 4 Channel oscilloscope, Tektronix TDS 3054 500 MHz

• RCL - Measurind device, Fluke PM 6304

• Three channel gauss meter 9950, vendor Co. F.W. Bell, with associated Magnaprobe for magnet fields,with
     frequencies ranging from 0 to 50 KHz

• Fluxmeter F1, Vendor, MAGSYS

• Cryo-scanning electron microscope ISI DS 130

• Amplifier AG 1006 LF Power (20kHz to 10 MHz), T&C Power Conversion Inc.

Measuring Software/Evaluating:

• Dasylab

• Diadem

• Origin

Current- and Powersupply:

• High voltage power supply, 60kV ati 3mA (+/- reversal polarity),Vendor Heinzinger

• Programmable power supply, ranging from 0 to 35V and 0 to 45 A, vendor, Co. Delta Electronic.

• NF – Power Amplifier 500 W, Vendor Thiel

• Signalgenerator / Synthesizer 6062A, Vendor, Fluke

• Various small signal generators, single and double power supply units, hand – and table multimeter,
     Vendor, Fluke

• Portable power supply unit, mobile usage

Top quality Sensors:

• Temperature ( DKD recirculating)

• Pressure

• Vibration

• EMV Measuring Antenna

 Laboratorytechnik:

• Highvacuumsystem (10^-9mbar), 35l glaschamber (Volume extendable )

• Highvacuum-coatingmachine BAE 250

• Hightemperature furnace (1600°C)

• Hardening furnace, Heraeus (1150°C)

 Cryo-Equipment:

• Mechanial workshop (Lathe, upright drilling machine, welding machine, 20t Hydraulicpress, Compressor up to 100 bar